Useable on any workable material e.g. steel, precious metals, glass, ceramics, plastics, precious stones, etc.
Stable housing of fibreglass reinforced POLYAMIDE. With soft component in the finger grip area for extended use.
The MICROMOT standard 20mm collar allows use in the drill stand MB 140/S, stand UHV and angle adapter WS 90.
The tens of thousands of these units in use speak for themselves: they are a joy to use. Here is why they are so loved:
The diameter of only 35mm makes it easy to handle. The weight of 230g, quietness and effortless drive via the special motor, ground spindle and collar bearing all contribute to the ergonomic design.. The size of the machine dictates a 12V drive system, use of a transformer is thus required. Micromot transformers of at least 1A are recommended.
The thyristor electronic speed control enables the selection of speeds from 5,000 to 20,000rpm. Phase angle control and feedback effect circuitry yield high torques, even at low speeds. Keyless chuck with 0.3mm - 3.2mm capacity .Power consumption is 40W max.